Currency USD
IHA-177 General Purpose 1 Quart Stud Welding Adhesive buy in Miamisburg
Buy IHA-177 General Purpose 1 Quart Stud Welding Adhesive
IHA-177 General Purpose 1 Quart Stud Welding Adhesive

IHA-177 General Purpose 1 Quart Stud Welding Adhesive

In stock
Reconfirm the price with seller
Shipping:
Seller
USA, Miamisburg
(View map)
+1(9 
Display phones
Description
Product Data Sheet for Anchor Adhesive

Anchor Adhesive is a high strength, heavy-bodied adhesive, specifically formulated for adhering anchors for hanging insulation. Anchor Adhesive bonds metal and nylon anchors to metal, concrete or masonry surfaces. Can also be used to install metal or ceramic wall fixtures in tile applications. Anchor Adhesive is also recommended for use as a general-purpose construction adhesive in applications requiring a high strength bond, or in applications subjected to high temperatures.

♦ Excellent thermal shock resistance
♦ Water resistant
♦ Mildew resistant
♦ High bond strength
♦ Immediate grab
♦ Non-slip formula

DIRECTIONS FOR USE:

1. Use only after careful consideration of the warnings, directions, and first aid instructions given.

2. Surface Preparation: Surfaces to be bonded should be clean, dry and free of any dust, frost, wax, moisture, dirt, grease, oil, rust, or other contaminants. Do not use over painted surfaces. Many protective coatings are not compatible with Anchor Adhesive.

3. Adhesive Preparation: Adhesive should be stored at room temperature (60ºF to 80ºF) for at least 24 hours prior to use.

4. Working Temperature: For best results, adhesive and materials to be bonded should be 30ºF to 120ºF.

5. Adhesive Application: Do not apply at temperatures below 30ºF. Prepare and install one anchor at a time. Apply a dab (the size of a small walnut) of adhesive to the anchor base with a putty knife and immediately (maximum open time is 10 minutes) press anchor firmly into place, with a slight twisting motion. For proper adhesion, insure that the film of adhesive covering the anchor base (after the anchor has been firmly pressed into place) is protruding

6. Installing Anchor Adhesive to Concrete Surfaces:
New concrete surfaces need to cure a minimum of 28 days in order to ensure best adhesion. All concrete surfaces should be high pressure water blasted or sand blasted to remove any surface curing agents and all foreign matter. Spread anchor adhesive on anchor base allowing solvent to flash off for several minutes before pressing anchor firmly into place with a slight twisting motion. Do not apply load until application is completely dry.

Contact the seller
IHA-177 General Purpose 1 Quart Stud Welding Adhesive
IHA-177 General Purpose 1 Quart Stud Welding Adhesive
We recommend to see
Shipping method
Compare0
ClearSelected items: 0